The OPW 295SA-0138 AVGAS fueling nozzle has a red composite lever guard that denotes AVGAS. The OPW 295SA-0138 has a 1 1/2" threaded inlet along with a 1 1/2" spout assembly. Comes with a built in swivel, ground wire assembly and dust cap.
Features
- Aluminum body - lighter weight, easier to maneuver.
- Dual poppets - easy-to-open nozzle against high inlet pressures.
- Color-coded composite lever guards - helps distinguish between AVGAS and Jet A. Easily replaced in lever guard kit.
- Right angle design - provides larger lever area for better grip and easier control.
- Vinyl-coated lever - insulates fingers against cold.
- 100 mesh strainer - prevents foreign matter from entering fuel tank; easy to remove and clean.
- Dust cap - keeps spout free from dirt and stops fuel drippage when connected.
- Adjustable dash pot - permits adjusting the main poppet closure rate over a wide range of flows to overcome line shock with minimum afterflow.
- Easily replaced spout - the spout is easily threaded into the body. Replacement spouts are readily available from OPW.
- Built-in swivel - eliminates twisting and kinking of the hose. This swivel is electroless nickel-plated and has full-bearing surfaces.
- NPT female threads at inlet end of 295SA - accepts all 1", 1-1/4" or 1-1/2" male connections.
- Ground wire assembly - included on all aviation nozzles.
Design working pressure
- 50 PSI (3.45 bar) maximum pressure
- Body: cast aluminum
- Main Stem: stainless steel
- Stem Seal: Buna-N O-ring
- Disc: Viton®
- Spout: aluminum
